# Xdrip resets and restarts with G6 and tslim:x2

**URL:** <https://forum.fudiabetes.org/t/xdrip-resets-and-restarts-with-g6-and-tslim-x2/9522>\
**Category:** DIY\
**Created:** [March 24, 2020, 1:42am UTC](https://forum.fudiabetes.org/t/xdrip-resets-and-restarts-with-g6-and-tslim-x2/9522 "2020-03-24T01:42:04Z")\
**Posts on this page:** 1\
**Showing post:** 3

<div class="post-metadata">

**Author:** ![MM2](https://yyz2.discourse-cdn.com/flex030/user_avatar/forum.fudiabetes.org/mm2/32/3032_2.png) [@MM2](https://forum.fudiabetes.org/u/MM2)\
**Post date:** [March 24, 2020, 6:41am UTC](https://forum.fudiabetes.org/t/xdrip-resets-and-restarts-with-g6-and-tslim-x2/9522/3 "2020-03-24T06:41:52Z")

</div>

There are several discussions here and will link to them.

High level, starting with 8G transmitters, it gets a bit more challenging.

To extend sensors, the auto extend does not work. The transmitter needs to be physically removed from sensor, without removing sensor. Then wait 20 minutes and then snap transmitter back on. Then treat it like a new sensor.

I have done reset (days) on 8G transmitter (via xDrip), but we have learned later 8Gs may have later software versions that prevent it. 8Hs may have even more limitations. The auto restart does not work, since transmitter now expects a disconnect of sensor, to make it think the sensor was physically changed.

I don’t have tslim, but use dexcom G6 Receiver for the sensor start/stop, and xDrip follows same data when Native is set. The Tslim pump should work same.

With 8G transmitter, I found it gets confused if I try start or stop sensor from xDrip.

Here is a previous post.

> [@The last two G6 sensors have stopped working after 10 days exactly using xDrip+, but didn't used to](https://forum.fudiabetes.org/t/the-last-two-g6-sensors-have-stopped-working-after-10-days-exactly-using-xdrip-but-didnt-used-to/8763):
>
> In the past xDrip+ would always keep on going after 10 days, for up to 30 days until the sensor actually died, now it seems like Dexcom has made the sensor die after 10 days so that xDrip says “sensor stopped”. I tried to re-start the sensor from scratch and it failed with the last sensor – am trying again right now with the next one. Has anyone else been having this experience? Is there a way to get around this so that xDrip+ keeps on going like it used to?

> [@Restarting G6 sensor failed? Help!](https://forum.fudiabetes.org/t/restarting-g6-sensor-failed-help/8928):
>
> @Nickyghaleb Restarted a G6 sensor on day 10 and it told me “single start sensor”. It got as far as starting the 2 hour warm up. The transmitter is 8H and was activated on 12-9-19. Any options? I used the no code 15 min warm up followed by the real code and it started the 2 hour warm up. I’m using the Dexcom receiver.

---

_[View the full topic](https://forum.fudiabetes.org/t/xdrip-resets-and-restarts-with-g6-and-tslim-x2/9522)._